Heat Resistant Paint

Heat resistant paint is a specialist protective coating engineered to withstand extremely high temperatures that would cause regular paint to fail instantly. Standard decorative paints will blister, crack, peel, and discolour when exposed to significant heat.

The secret to heat resistant paint lies in its formulation. It is typically made with silicone-based resins and heat-stable pigments. These components are designed to remain inert and stable at very high temperatures, creating a durable finish that protects the underlying metal.

It is the essential coating for surfaces that get extremely hot, including:

• Log burners and wood-burning stoves
• Fireplaces and fire surrounds
• Barbecues (BBQs) and fire pits
• Stove pipes and flues
• Vehicle exhaust systems and engine components

These paints are rated to specific temperatures, often ranging from 600°C (1200°F) up to 1000°C (1800°F), so it's important to choose the right one for your project.

Yes, heat resistant paint works exceptionally well, but only if it is applied and cured correctly. When you see a heat-resistant finish that has failed, it is almost always due to poor surface preparation or an improper curing process.

The paint works by using its silicone-based resins to form a tough, thermally stable barrier. However, this barrier only achieves its full strength after it has been properly cured by heat.

Think of the application as a two-stage process:

1. Application: The paint is applied and air-dries to a soft finish. At this stage, it can still be easily marked or scratched.
2. Heat Curing: This is the crucial final step. When the painted item is heated for the first time, the high temperature triggers a chemical reaction that cross-links the silicone resins, hardening the paint into its final, incredibly durable state.

Without the final heat cure, the paint will never achieve its designed hardness and will not provide lasting protection.

Correct application and curing are absolutely essential for a successful and durable finish. Follow this step-by-step guide for professional results.

1. Surface Preparation (The Most Important Stage):

• The item must be completely cold.
• Remove all loose rust, contaminants, and old, flaking paint using a wire brush and sandpaper. The goal is to get back to a clean, bare, stable metal surface.
• Thoroughly degrease the surface using a solvent cleaner or panel wipe to remove any oils, grease, or residue. The surface must be perfectly clean for the paint to adhere.

2. Application:

• Shake the aerosol can vigorously for at least two minutes.
• Apply the paint in several light, thin coats from a distance of 10-12 inches. It is much better to apply 3 thin coats than 1 thick, heavy coat.
• Allow 15-20 minutes of drying time between each coat.

3.Curing the Paint (The Crucial Final Step):

• Allow the paint to air dry for at least a few hours until it is touch-dry.
• The paint must now be cured by heat. Gradually raise the temperature of the item to around 200-250°C for 45-60 minutes. For a log burner, this means starting with a small kindling fire and slowly building it up.
• During this first heat cycle, the paint will emit some non-toxic smoke and fumes as the resins cure. This is a normal part of the process. Ensure the area is well-ventilated.
• Allow the item to cool down completely. The paint is now fully cured and has achieved its maximum hardness and heat resistance.