P55 incl Hardener
Tax included. Shipping calculated at checkout
In Stock
Why Choose Nebula Paints?
Mipa P 55 Glass Fibre Body Filler is a two-component, polyester resin-based body filler reinforced with glass fibres to deliver outstanding structural strength. Designed for direct adhesion across zinc, aluminium, steel, wood, and automotive plastics, it provides the ideal solution for bridging gaps, filling small holes, and repairing areas damaged by rust or corrosion.
| Attribute | Substrate |
| Colour | Grey |
| Binder Base |
Polyester Resin Wiht Glass Fibres |
| VOC Content | Max 25 g/l (EU limit 250 g/l |
| Mixing Ratio (Weight) | 100:2 (Body iller : Mipa Hardener P) |
| Pot Life | 4-5 Minutes (with Mipa Hardener P At 20C) |
| Sanding time | 20 Min (20C) /10Min (60C) / 4-5 Min (IR At Max 80C) |
Application & Processing Guidelines
Substrate Preparation: Ensure all surfaces are clean, dry, free of grease, and slightly sanded. Remove uncured old paintwork or acid primers (Reaktionsprimer).
Ferrous Metals: De-rust damaged areas to bare metal and dry sand using P 80/150 paper. Degrease using Mipa Silicon Remover Silikonentferner.
Non-Ferrous Metals & Restorations: For aluminium, galvanised surfaces, or vintage car restorations, apply Mipa EP-Primer-Surfacer prior to filling for optimal adhesion and rust protection.
Mixing: Mix 100 parts by weight of Mipa P 55 with 2 parts by weight of Mipa Härter P hardener (do not exceed 3% hardener to avoid spotting in the finish layer).
Application Conditions: Work above +10 °C (polyester body filler will not cure below +10 °C) and up to 80% relative air humidity.
Sanding & Finishing:
Dry sand only.
Initial dry sanding: P 150/240 grit.
Final dry sanding: P 240/360 grit to a matt finish before applying filler.
Isolation: Always isolate the body filler with a Mipa 1K or 2K filler prior to applying topcoats.
Choose options